How to prepare your surface for the Epoxy Floor Kit?

How to prepare your surface for the Epoxy Floor Kit? –

metallic epoxy floor coating showing everything that is included with metallic epoxy floor paint kit.
Best metallic epoxy garage floor paint in a metallic epoxy floor coating kit.

‘Proper preparation prevents poor performance’, the quote is valid for all spheres and coating industry isn’t an exception. While some in the floor coating industry hold on to the belief that preparing the surface is an irrelevant task, time and again, they’ve been proved wrong with various evidences. Of course, the quality and chemistry of the floor coating kit matters, but the longevity and success is also determined by how properly the substrate was prepared before the coating was applied.

Here, we bring you a few tips on how to get the best out of your DIY floor coating kit:

Clean the surface

Examination and analysis of the substrate is quite an evident first step to the preparation. While the older concrete shows effects of temperature and various chemicals, the newer one is a bit of a darling to deal with.

Old concrete floors have been exposed to various chemicals, greases and moods of the temperature, they should be thoroughly cleaned before the coating is laid upon. The newer concrete floors need cleaning too before the coat is applied, not really vigorous though.

Remove extras

Remove any previous coatings and paints that are there on the floor, uneven substrate might hinder with the sticking properties of the solution, vacuum it again to remove impurities.

Mechanical treatment

The most important factor while applying the epoxy floor coatings to concrete is to remember that the ultimate motive here to make sure that the substrate allows proper adhesion. And to ensure the same happens, mechanical preparation of the surface is imperative! There are various ways by which this motive can be achieved. Acid etching is one technique that doesn’t requires any machinery. The most commonly used equipment are the grinders, they complete their task without breaking or fracturing the surface of the substrate.

For more adamant surfaces, shot blasting techniques can be used. The technique involves throwing small steel balls against the surface to remove a thin layer of the surface.

Fill all cracks and holes

This step can be undertaken according to suitability, before priming or after it, whatever appears to be the best. All cracks and concrete holes should be taken care of before the coat is spread out.

Remove dark stains

Search the entire area for color variations or stains. Use a soft bristle brush to remove if any found. Usually, the corners and sides are the ignored ones, brush them to make sure they are treated equally. Just make sure to not use a hard bristle brush if not required, you might damage the substrate.

Prime the surface

It is a common misconception that priming of the surface is not necessary, but if you want to increase the life of your epoxy floor coat, never, I repeat, never ignore priming, unless stated otherwise. It increases adhesion and discards the risk of formation of bubbles and gasses. Just remember to use the proper mixture.

Once all the steps have been completed, all old coating gone and you can feel the presence of perfect surface profile, it’s time for the application.

If you are looking for the most technologically advanced Epoxy Floor Coating Kit manufactured in USA, then The EpoxytechKit is your answer.

Click here to view the beautiful options and their technical details made available by EpoxyTech. Order the epoxy floor coating kit directly from us at a reasonable rate.

Contact Details:

Phone1-855-95-EPOXY

Email[email protected]

 

epoxy-garage-floor-paint-coating-asseen

Get the Epoxy + Tech Advantage!

Visit More Info On Our Blog   |    See us on FB      |   or via Twitter

How to Contact WordPress Website Support phone number?

Related Posts:

Why Epoxytech?

If you are planning to give your surface a beautiful...

Why your garage needs an epoxy flooring?

It’s an undebatable fact that garages these days are an...

How Epoxy is better than anything else?

If you want something on your floor that catches every...